top of page

Decal Installation Instructions

  • Unpack and inspect your decals as soon as they arrive. Any suspected damage must be reported within 24 hours of receipt.

​

  • Always handle decals with care and do not fold or bend. 

​

  • Our frosted window decals are created to be installed internally unless requested otherwise. 

​

  • Please watch the instruction video below which demonstrates the ‘wet method’ of application. This is the preferred method of installation for those who have never installed a window decal before.

​

  • When you receive your decals unpack them, lay them out and gently smooth them flat. Leave them flat until it is time to install, do not roll them back up again. 

​

  • We recommend using a small squeegee (preferably felt cover) to apply the decals.  

​

  • The decal is repositionable when the window and vinyl are still wet. Once any part is allowed to dry it is are no longer repositionable.

​

  • In some decals where the design doesn’t take up the full panel the transfer application tape may cover just that section and not the full decal. 

​

  • Make sure any bubbles or raised fingers are carefully flattened out by smoothing them out to the edges. 

​

  • The recommended liquid solution consists of 4 drips of baby shampoo or washing up liquid per litre of water.

​

  • Once applied and smoothed out using the squeegee, decals should be left in place for at least 48 hours before removing the final transfer application tape. 

​

  • If you are left with any bubbles or water spots these will usually go down over time. Alternatively, you can burst them with a pin and carefully squeeze and heat them down with a hair dryer or heat gun. 

​

  • We accept no responsibility for improper installation or damage where these instructions are not followed. If you have any questions or need assistance at any point, please don’t hesitate to get Intouch and we will happily help. You can contact us during business hours at info@attentiontodetailgifts.co.uk.

bottom of page